There are many ways to remove a ring. At the beginning, most people don’t want to break the ring, so they can only be squeezed out. Usually we will first remove the ring by lubrication, including soap, glycerin, or other oily products to achieve lubrication, but as time goes by, if it can not be removed within a few minutes, it will enter the swelling period. . But in general, the part of our ring is stuck at the joint, so just push the ring back to the proximal end to reduce swelling and restore blood flow. However, sometimes the removal time is too long, which will cause the veins of the reflux to be blocked. At this time, the swelling will start, and once the fingers become swollen, the blood supply to the artery will be oppressed. At this time, the ring can only be destroyed. Otherwise it is difficult to remove the ring. 1. If the ring is too hard to be destroyed or taken out in a way that does not damage the ring, the method is to try to drive the blood at the distal end of the finger back to the end of the ring.
Therefore, raising the hand higher than the heart is a way to wait for the swelling to be removed. In addition, the front end is bundled from the distal end to the proximal end by means of plate wire or elastic rubber, and then the ring is slowly taken out after a while. But in fact, if you have the patience to slowly use lubrication and rotation, under moderate local anesthesia, before the swelling has been inserted into the skin, it can be removed for a while, but the skin on the finger Inevitably it will damage. 2, Secondly, if the swelling is embedded in the skin and the ring cannot be moved, the above method will not work, so it can only be removed with tools. There are several tools traditionally used to remove rings. In addition to the ring tongs, other tamper pliers can be used to cut the ring, but when using a tool to break the ring, the most fear is that the ring is too hard. Sometimes it is difficult to find tools to destroy. Therefore, in addition to protecting the inner skin of the ring in the process of destruction, it is not an option to make a gap in the ring and then destroy it with a suitable tool along the gap. If these methods can not remove the ring or cause necrosis of the finger due to long-term ischemia, then you can only enter the operating room and anesthetize the hand Knock off cartier jewelry, then debride and remove the ring in the open room. 3, when choosing a ring, you must choose the appropriate ring, and it is best not to be too hard to cut difficult. If you find that you are pregnant or gain weight, you must pay attention to whether the ring worn before is stuck in the finger. Once you find it, it is best to remove it if it is not too swollen, otherwise wait until the whole finger is The edema has to be removed, usually it takes some effort to get the sausage back to the small hot dog, and the skin of the hand is inevitably partially damaged during the removal process. Generally, the fire brigade or the medical institution providing emergency treatment can help the public to deal with these problems. If the soapy water can’t fade, your ring is really tight! Recommend a few methods that should solve your problem: 1, first of all to pay special attention: in the case of the ring is difficult to fade, do not fade strongly – the ring becomes more difficult to fade out! 2. Under the premise that your fingers are not swollen (otherwise you must first eliminate the swelling), use some ice to quickly cool your fingers, so that the fingers will shrink colder, then fully lubricate with vegetable oil, and slowly rotate the ring. Note: Fingers should not be left in ice or cold water for too long, otherwise the fingers may become larger due to long-term soaking, making the ring more difficult to remove. 3, spend about 10 yuan to go to the pharmacy to buy a human body lubricant, the lubrication effect is much better than the general thing, it should make the ring fade smoothly. 4. If the above two methods are not working, then your ring is very dangerous to you. If you don’t fade for a long time, it may lead to necrosis of your fingers. You should go to the hospital to solve it! 5. See if you can use a toothpick to pass the ring? 6, if you can, first use the ice water bubble hand, then use a toothpick to pass through the ring, pass a line in the gap of the toothpick, and then use a wire around the finger (the purpose of the finger meat is solid), after a width of one or two millimeters , withdraw the ring a little bit, then continue to wrap around a millimeter… and so on.